Support our site!
Use code*

*Some restrictions apply

 Questions, Comments or Feedback

This section will show the stages of a polish as it breaks down.

Each polish is different but all will go through basically the same stages - wet, haze, translucent, dry or oily.

Speed, pad and pressure depends on what needs to be removed, but always start with the least aggressive pad/polish combo first.

· Polishes Demonstrated ·

Poorboys SSR2.5

Below is the breakdown stages of Poorboys SSR2.5 using the Porter Cable 7424 and a Meguiar's Polishing pad.

Amount of SSR2.5 to use
Keep in mind that this is amount I use on a fresh pad.
After the pad has been primed, the amount is about half shown below.
Spread the polish around the area before turning on the Porter Cable to help prevent splatter.

Spread the polish over the area at speed 3-4.

Breakdown Stages
Turned the Porter Cable to speed 5 and started to work the polish using slow overlapping movements

At this point the polish is broken down and ready for removal.

| Home | Exterior | Interior | Polishing | Videos | Gallery | Disclaimer | About | Contact us |
| Recommended Products |
© 2003-2012